Thingiverse
PLA FanDuct for Bowden X-Carriage Mount for E3D V6
by koshu
22
Downloads
13
Likes
1
Makes
Had a problem with the original design where the fan duct slowly started to sink when printed in PLA. Most likely because of the heat and since it started to get very close to my prints I made this remix to give the fan duct a bit more stability.
Big thanks to Prometheus3D for his neat Carriage.
Big thanks to Prometheus3D for his neat Carriage.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in