Fidget Spinner "Fidgey"

I made this in AutoDesk 123D, as my first design. I see a lot of fidget spinners around and I figured, "Hey, why don't I make one that will spin for a long time!".

Printed on a Flashforge Creator Pro in IC3D Orange ABS

Printed at 0.14mm Layer Height, pretty much any layer height is fine.

I printed this at 100% infill for maximum durability, but it doesn't really matter what you have for it. I would recommend 15-100%.



IF PRINTING IN PLA, DO NOT POUND BEARINGS IN!!! IT MIGHT BREAK