Thingiverse
Death Star Grinder
by 3Dash
1.5k
Downloads
1.4k
Likes
3
Makes
Death Star grinder with small tripod preventing it from rolling away. It consists of 6 3D printed parts, including the display stand, and some electronics I extracted from a small flash light.
Most of the parts are screwed together except for the upper and lower part of the grinder these are held together by two magnets (Diameter: 6mm, Height: 3mm). Make sure you glue the magnets in the right direction.
The light source is a 3V LED which was soldered to a small PCB but you could also use a
Most of the parts are screwed together except for the upper and lower part of the grinder these are held together by two magnets (Diameter: 6mm, Height: 3mm). Make sure you glue the magnets in the right direction.
The light source is a 3V LED which was soldered to a small PCB but you could also use a
Sign in to leave a comment
Sign in