Wanhao Duplicator 6 Filament Runout Sensor

This is a bracket to mount an nc microswitch sensor on a Wanhao Duplicator 6/Monoprice Maker Ultimate to detect when filament runs out. To be able to use this feature you will need to install a custom Marlin firmware that was developed for the D6/MU:

https://github.com/1bigpig/Marlin

Parts required:

1 nc microswitch similar to that seen in the photo
1 male 3pin JST connector to connect the microswitch to the board
2X m2x12mm screw
2X small sections of PTFE tubing to insert into both