Thingiverse
Tired of these fidget spinners yet?
27
Downloads
32
Likes
0
Makes
I've been printing a lot of these spinners lately and decided to make a few of my own. They're very basic as far as design goes, but I added a few things that I felt were missing from other spinners. These spinners are about 0.5mm thicker than the bearings. This is because I sand both flat faces of the spinners and brush with acetone to get a nice finish.
I found I got better spins when the outside bearings were closer to the inside. Also, the more weight to the outside meant more momen
I found I got better spins when the outside bearings were closer to the inside. Also, the more weight to the outside meant more momen
Sign in to leave a comment
Sign in