Wanhao Flex Plate for Micro Swiss - Realigned

The original plate didn't work well for me, as the hole was too small, and the lever was not aligned properly with the drive gear, so I made a new version and it works better for me. YMMV.

This only works for the MK10 gear, I made a separate one for the MK7 gear (which is slighly larger, and with the hole a bit offset).

I recommend using this lever: http://www.thingiverse.com/thing:1637225

Print with PETG with good infill (I used 80%), and good resolution (I used 0.12). Need support at