Thingiverse
EDGE - A Snap Together Fidget Spinner
by TrkDesigns
25
Downloads
21
Likes
0
Makes
This spinner uses 3 22mm bearings, 2 of them fit in the spaces inside the spinner. After you position those first two, snap on the top of the spinner, and fit the middle bearing into the center hole. Now you can pop the caps in. It may be tempting to hammer the caps in, but don't because it could cause the first layer to peel off. Finally, make sure the caps are flush with the top and bottom of the spinner. Enjoy!
Sign in to leave a comment
Sign in