Thingiverse
Creality Spool adaptor
by SizZLeR
294
Downloads
135
Likes
4
Makes
Spool adaptor to fit the Creality spool arm to prevent the spool from tumbling and cause under-extrusion.
I made this because when I adjusted my extruder steps per mm, I tested the impact of the counter drag from the spool which turned out to cause massive under extrusion.
The impact was about 1-2mm of under extrusion, especially when the extruder pulls the filament enough to initiate a spool revolution but then retracts and refeed again, the spool would bounce, causing quite a pull and le
I made this because when I adjusted my extruder steps per mm, I tested the impact of the counter drag from the spool which turned out to cause massive under extrusion.
The impact was about 1-2mm of under extrusion, especially when the extruder pulls the filament enough to initiate a spool revolution but then retracts and refeed again, the spool would bounce, causing quite a pull and le
Sign in to leave a comment
Sign in