Thingiverse
Drive Shaft Bellows Retaining Ring Installation Tool
by MortalTombat
22
Downloads
16
Likes
0
Makes
I'm apparently too cheap to buy the $30 tool from the local boat shop. This tool is meant to be used in a push-in (vs tap in) installation of the driveshaft bellows retaining ring.
there are three versions:
20mm solid (no cut outs, for folks who want to try the tap in method, I suppose)
***20mm with cut outs and 10mm hole in the center (I have printed and tested this one)***
22mm with cut outs and 10mm hole in the center (the 20mm version leaves a small gap at the small end of the ring
there are three versions:
20mm solid (no cut outs, for folks who want to try the tap in method, I suppose)
***20mm with cut outs and 10mm hole in the center (I have printed and tested this one)***
22mm with cut outs and 10mm hole in the center (the 20mm version leaves a small gap at the small end of the ring
Sign in to leave a comment
Sign in