Thingiverse
Kossel Carriage, integrated belt clip and screw for endstop
by Bjoern85
39
Downloads
25
Likes
0
Makes
This is a carriage designed for my delta printer, which i am building at the moment.
Should be used togehter with http://www.thingiverse.com/thing:2301009
"V2":
- The two holes for the M3 nuts are deeper. So i can use these parts:
https://www.3dware.ch/Kugelgelenk--M3-auf-M3-6-Stk.-De.htm
- The thing has a 20mm deep hole for M3 screws to adjust the endstop.
- You can clip the GT2 belt together, like i did oder put the lose end in the slot whit the printed GT2 profile. The profile is the
Should be used togehter with http://www.thingiverse.com/thing:2301009
"V2":
- The two holes for the M3 nuts are deeper. So i can use these parts:
https://www.3dware.ch/Kugelgelenk--M3-auf-M3-6-Stk.-De.htm
- The thing has a 20mm deep hole for M3 screws to adjust the endstop.
- You can clip the GT2 belt together, like i did oder put the lose end in the slot whit the printed GT2 profile. The profile is the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in