Thingiverse
ANET A8 extruder fan mount
by SmallArtFly
19
Downloads
5
Likes
0
Makes
Anet A8 extruder fan mount
you can easy remove the fan to look were the filament is going
-The heatsink in this design is removed
-Holes in the fan are tapped M4
-M4x10 bolt is used for the fan and to attach on the bearing block
(i know the part in the picture is bad that was printed WITHOUT support)
you can easy remove the fan to look were the filament is going
-The heatsink in this design is removed
-Holes in the fan are tapped M4
-M4x10 bolt is used for the fan and to attach on the bearing block
(i know the part in the picture is bad that was printed WITHOUT support)
Sign in to leave a comment
Sign in