Thingiverse
Cryorig C7 120mm Fan Adapter - Center/Offset
by theHACK
74
Downloads
47
Likes
0
Makes
Allows you to use standard 120mm fans. Optimized for easy printing. Heatsink is 32mm high. Uses standard case fan screws to attach to fan.
Offset Type 1(A/B): The adapter adds 2mm to heatsink. Fan is offset at one corner. The footprint falls within 95x95mm zone at two sides, so it will fit with high profile RAM. Type A/B are mirrored of each other. Download the STL and see which type you need.
Center Type 1: The adapter DOES NOT add any height to heatsink. It is dead centered, low profile.
Offset Type 1(A/B): The adapter adds 2mm to heatsink. Fan is offset at one corner. The footprint falls within 95x95mm zone at two sides, so it will fit with high profile RAM. Type A/B are mirrored of each other. Download the STL and see which type you need.
Center Type 1: The adapter DOES NOT add any height to heatsink. It is dead centered, low profile.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in