Printrbor simple glass bed holder

This is a glass holder for the printrbot simple metal with the 10" X axis upgrade. It slides into the slots on the side of the bed and expands to hold the glass.

The glass I am using is 6-5/8" x 10-1/4" x 1/8". You will need 4 M6x25 hex bolts, 4 M6 hex nuts, and 4 M6 flange nuts.

Use a soldering iron to press the flange nuts into the thumb screws.

I am using aluminum duct tape under the probe points to make the autolevel sensor work.