Thingiverse
Anet A6 Power Switch
by Korgano
65
Downloads
29
Likes
1
Makes
Anet A6 power switch
---------------------
I was not able to find an existing thing to install a power switch at the back of the printer for the original power supply so i created this one.
### Installation
The top hole of the switch was designed to align with the hole at the power switch thats why you need 40mm screws. Because of the small space its a bit hard to fit the screw at the inner side. i used a short (~9cm) screwdriver for this. Since i am not an electronics expert i was not awa
---------------------
I was not able to find an existing thing to install a power switch at the back of the printer for the original power supply so i created this one.
### Installation
The top hole of the switch was designed to align with the hole at the power switch thats why you need 40mm screws. Because of the small space its a bit hard to fit the screw at the inner side. i used a short (~9cm) screwdriver for this. Since i am not an electronics expert i was not awa
Sign in to leave a comment
Sign in