Thingiverse
Feiyu G5 Hero 5 Conversion
by jasonmartins
13
Downloads
12
Likes
0
Makes
Using this Mount, you can use your Feiyu-Tech G4 for the Hero5.
I Was able to print it in PLA with 230°C and 2000mm/min on my kossel XL, strength seems to be fine, however, be careful, it is still plastic, not metal as the original piece.
i wasn't able to perform a full test, as i broke my gimbal while turning it on without all cables connected, so be warned!!!
I Was able to print it in PLA with 230°C and 2000mm/min on my kossel XL, strength seems to be fine, however, be careful, it is still plastic, not metal as the original piece.
i wasn't able to perform a full test, as i broke my gimbal while turning it on without all cables connected, so be warned!!!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in