Thingiverse
1/8" D Shaft Skirted Knob
by Webweave
2
Downloads
4
Likes
0
Makes
1/8" D shaft skirted knobs are real expensive, I needed a couple so I made these. I filled the pointer line with WhiteOut for contrast.
The photo shows the nut and bolt needed to clamp the knob to the shaft.
It's quite the pain to design this in Tinkercad but you can do it so I did but there's more holes than solids.
I built two versions, one pointer facing flat and one pointer away from flat because to change it later would have been harder in this non parametric modeler. Print the
The photo shows the nut and bolt needed to clamp the knob to the shaft.
It's quite the pain to design this in Tinkercad but you can do it so I did but there's more holes than solids.
I built two versions, one pointer facing flat and one pointer away from flat because to change it later would have been harder in this non parametric modeler. Print the
Sign in to leave a comment
Sign in