![Anet A8 Front Frame Brace [Superstiff] – 3D printable model from Thingiverse](https://wsrv.nl/?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2Faf%2F51%2Ff7%2F9f%2F4a%2Fc52ecbe864631005ccd231e286682946_display_large.jpg&w=800&h=800&fit=cover&output=webp&q=80)
Thingiverse
Anet A8 Front Frame Brace [Superstiff]
by Gatekeeper74
330
Downloads
198
Likes
9
Makes
Basically the same as Leo's thing (https://www.thingiverse.com/thing:1857991) which is pretty much an improvement.
Though i had to add a little piece that wraps through the bottom gap of the original frame part and prevent its lower outer edge from bending too. Fits perfect to my A8 and gives Leo's thing a good pinch of extra stiffness.
**NOTE:**
Make sure that your slicer program is set to 100% scale. You will also need to rotate to object 45 degrees to make it fit on the heat bed.
Ha
Though i had to add a little piece that wraps through the bottom gap of the original frame part and prevent its lower outer edge from bending too. Fits perfect to my A8 and gives Leo's thing a good pinch of extra stiffness.
**NOTE:**
Make sure that your slicer program is set to 100% scale. You will also need to rotate to object 45 degrees to make it fit on the heat bed.
Ha
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in