Tronxy X1 bed tightener

UPDATE: edited Part A and B to leave more room for the bearings, so they don't rub.



A screw controled tightening system for the Tronxy X1's sometimes wobbly y-bed.

I did previously use the model from PB2000 https://www.thingiverse.com/thing:2203872 , but either i was doing something dumb, or my matrial wasn't good enough; the bed started wobbling again after a couple prints.

Part C and D are optional and made to fit the spare M5 screw i had leftover. Required is a M5 Nut + a M5 scr