Thingiverse
Top Load Filament Spool Brackets - 2020 T-Slot Aluminum
by darrenah
8
Downloads
4
Likes
0
Makes
I know there are a lot of Top Loading Spool Holders similar to this set, but I couldn't find a set that worked exactly like I wanted it to, so I designed these. I designed them not to need any screws or other hardware, other than the cross bar (7mm threaded rod) that came with the printer.
It's designed to have the center of gravity off center, so that it will "lean" forward, holding it in place and without too much lean, so that it won't put too much pressure on the backside hook. You ca
It's designed to have the center of gravity off center, so that it will "lean" forward, holding it in place and without too much lean, so that it won't put too much pressure on the backside hook. You ca
Sign in to leave a comment
Sign in