Thingiverse
2-way and 3-way Marble Spinner
by Lonestar356
21
Downloads
14
Likes
0
Makes
These are two simple Fidget Spinners, each takes less than an hour to print, they require no supports. they are sized for longboard bearings, and to add weight they are perfectly sized for marbles to snap into the end. to be fair, I didnt use marbles from a marble set, I used marbles that i cut out of spray paint cans, but if they are the same size they should work fine. I plan on uploading a version that works with steel bearings too. as you can see one of the buttons has a hole in the top, i d
Sign in to leave a comment
Sign in