Thingiverse
Dial gauge holder for Raise3D N2 & N2+
by Yombus
72
Downloads
52
Likes
2
Makes
Small tool to hold a Dial gauge with a Ø8mm body rod
unplug and remove the left side fan and use the same threaded holes to attach the tool.
-the tool may be mirrored if you need to attach it to the right side.
This is the most rigid geometry (no angles, tall enough for holding the gauge in cantilever with virtually no flexion)
Also, if you don't have any screws you may also print the shim, and use the stock screws, with the fan attached.
and adjust the clamp diameter to be the same s
unplug and remove the left side fan and use the same threaded holes to attach the tool.
-the tool may be mirrored if you need to attach it to the right side.
This is the most rigid geometry (no angles, tall enough for holding the gauge in cantilever with virtually no flexion)
Also, if you don't have any screws you may also print the shim, and use the stock screws, with the fan attached.
and adjust the clamp diameter to be the same s
Sign in to leave a comment
Sign in