Taranis Q X7 Gimbal Guard Protector

I didn't see a lot of options for Taranis QX 7 gimbal guards so I created this one. The bridge between the gimbal guards sits fairly low and level, which is by design, as I wanted it to be able to be about flush to the lanyard hook. The notch is supposed to be tight so it can hold the protector in place. This model require supports to print, but it's not too bad- a little over a 2 hour print at .30 on my printer.

The notch cut out may be a little bit of a tight fit so it holds the gimbal gua