Thingiverse
Final Design for Press Reset Challenge #SKATEFORCE (Single stud wall mount-smoothed out trucks holder)
by jjflugum
28
Downloads
18
Likes
1
Makes
This was tested with all of the weights I have at 46lbs, the thing didn't even budge a little. It was solid as a rock. The print material was done with Zyltech PLA 1.75mm. (Cheap stuff $11.45 per 1kg on eBay) It is not the greatest to work with but it proves that even cheap filament can hold a ton of weight. The print settings were 210C and 65C on the bed at 60mm/s with 25 Percent infill. The time it took to print was just over seven hours. This was secured to the wall with just one-inch long ro
Sign in to leave a comment
Sign in