Thingiverse
FlashForge Pro Fan Holder
3
Downloads
5
Likes
0
Makes
This is a remix of two ideas:
https://www.thingiverse.com/thing:327387
https://www.myminifactory.com/object/flashforge-creator-pro-fan-duct-2058
It is a 'press-fit' holder that mounts onto the FlashForge Carriage under the right Extrude Fan.
It takes a 10mm deep 40mm Duct Fan.
We prefer an independently wired outside power supply for the Fan with a switch to turn the Fan on/off FYI.
You can remix this to fit the left side too.
BUT a Dual Fan assembly may be unfeasible ... but not to
https://www.thingiverse.com/thing:327387
https://www.myminifactory.com/object/flashforge-creator-pro-fan-duct-2058
It is a 'press-fit' holder that mounts onto the FlashForge Carriage under the right Extrude Fan.
It takes a 10mm deep 40mm Duct Fan.
We prefer an independently wired outside power supply for the Fan with a switch to turn the Fan on/off FYI.
You can remix this to fit the left side too.
BUT a Dual Fan assembly may be unfeasible ... but not to
Sign in to leave a comment
Sign in