Thingiverse
Gears of War Cog Fidget Spinner - Wingnut2k
by wingnut2k
28
Downloads
28
Likes
0
Makes
Per a request, here's a Gears of War Cog fidget spinner that I came up with. This spinner uses (8) 1/4" ball bearings and (1) 608 skateboard bearing. This spinner is about 3-3/8" in diameter overall.
I would heat up the print and ball bearing with warm water and the bearings will slip in. I haven't tried printing this yet, but the balls should be very tight to snap in.
I would heat up the print and ball bearing with warm water and the bearings will slip in. I haven't tried printing this yet, but the balls should be very tight to snap in.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in