Thingiverse
5" LCD Pi Box / Case
by Athruz
36
Downloads
21
Likes
1
Makes
6-21-17- Added the new Pi stand I use; this one clamps around the entire body and front cover. Its a tight fit but works and holds well.
6-9-17 Added a stand - Left and Right High Res STL's (print laying flat obviously)
Printed and revised 5/28/17: removed the fillet on the inside for tolerances, fixed one vent that was jacked up somehow- not sure what happen...
Added 5/27/17: Added a recess for the ribbon cable, the lid is directional so make sure to line up the slot and wider section
6-9-17 Added a stand - Left and Right High Res STL's (print laying flat obviously)
Printed and revised 5/28/17: removed the fillet on the inside for tolerances, fixed one vent that was jacked up somehow- not sure what happen...
Added 5/27/17: Added a recess for the ribbon cable, the lid is directional so make sure to line up the slot and wider section
Sign in to leave a comment
Sign in