Thingiverse
Anet A8 X-Axis brace
17
Downloads
19
Likes
0
Makes
Summary
Preview Text Markdown Enabled
How I Designed This
Text Block
Fusion 360
Hey guys, this is an experimental proto-type. Print at your own risk :)
If the braces dont fit tightly a little hot glue should do the trick without damaging anything.
Also, warning I have not yet printed this out myself as I ran out of filament. But check the measurements if you're afraid to pull the trigger.
You need to remove the top plates of the Anet-A8 slot them into the printed part a
Preview Text Markdown Enabled
How I Designed This
Text Block
Fusion 360
Hey guys, this is an experimental proto-type. Print at your own risk :)
If the braces dont fit tightly a little hot glue should do the trick without damaging anything.
Also, warning I have not yet printed this out myself as I ran out of filament. But check the measurements if you're afraid to pull the trigger.
You need to remove the top plates of the Anet-A8 slot them into the printed part a
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in