Thingiverse
TX03 Mount for Eachine Micro Skyhunter
by dalgibbard
17
Downloads
12
Likes
0
Makes
This is a remixed TX03 Camera mount designed for the Eachine Micro Skyhunter.
Not yet tested; but designed to screw into pre-drilled 20mm separated holes on the canopy section. Holes on the mount are designed to take M2 (2mm) self-tapping screws to affix to the FPV canopy, and will accept screws with heads up to 6mm (which should include flanged heads too).
Also added a flat front and gradient edge to the camera base to allow for support-less printing. Rounded the back edges off for aesthe
Not yet tested; but designed to screw into pre-drilled 20mm separated holes on the canopy section. Holes on the mount are designed to take M2 (2mm) self-tapping screws to affix to the FPV canopy, and will accept screws with heads up to 6mm (which should include flanged heads too).
Also added a flat front and gradient edge to the camera base to allow for support-less printing. Rounded the back edges off for aesthe
Sign in to leave a comment
Sign in