Armattan Chameleon camera bumper

This is kind of a bumper to reinforce the Chameleon's camera frame and avoid it from bending.

It does not required any support. I print placing the side in the printer bed and using rafts. Infill 20% should be fine.

It's still under development and any suggestion would be welcome :)

NOTE: If you're looking for someone that could print this part for you, check Brent Collier/BMC3D @ https://bmc3d.co/

https://bmc3d.co/collections/chameleon-accessories/products/chameleon-camera-brace?v