Vintage light unit on tripod

This is a mixture of parts some 3d printed, some simple items you may have at home, and a purchased vintage light head.

The 3d printed parts consist of
Light centre 1 off required
face plate 3 off required
Tee piece 1 off required
Tube ends 6 off required.
Legs are made from 30x18 pine. These have been coated in Danish oil, but the finish is up to you.
I have used M6 x 25 x 8
M6 Nuts x 2

The centre block needs to be tapped m6

The light support is made from small sections of 15mm