Thingiverse
Drela AG35 Airfoil Micro Drone Propeller (37.25g thrust @ 3V)
by emanuelbucsa
9
Downloads
3
Likes
0
Makes
The micro drone propeller has been designed after the **Drela AG35** airfoil. It was tested on the **[Micro Drone Propeller Thrust Tester](http://www.thingiverse.com/thing:2302071)** (test results provided below).
It was printed slowly, with the help of a **[0.2 nozzle](http://amzn.to/2qQdFvg)** at 0.04 height per layer. The final part was cleaned using a **[Precision Knife](http://amzn.to/2pV1sGA)**
After this, I got to finishing the part with a small piece of **[500 grit sandpaper](http:
It was printed slowly, with the help of a **[0.2 nozzle](http://amzn.to/2qQdFvg)** at 0.04 height per layer. The final part was cleaned using a **[Precision Knife](http://amzn.to/2pV1sGA)**
After this, I got to finishing the part with a small piece of **[500 grit sandpaper](http:
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in