Thingiverse
Xbox controller Wall Mount
by beerman_uk
51
Downloads
37
Likes
0
Makes
Remixed as the original had quite a chunky profile.
The arms have been given an extra 2mm as the original ones were a bit flimsy.
Works with the headset adaptor and fits the edge of an Ikea lack table perfectly (although it can go anywhere).
Update:
I've added the inserts for the xbox logo. Just print them off and push fit them in place. I needed to sand a thin bit off each edge but then just used the butt of a screwdriver to hammer them in place. I just wish I had some green fila
The arms have been given an extra 2mm as the original ones were a bit flimsy.
Works with the headset adaptor and fits the edge of an Ikea lack table perfectly (although it can go anywhere).
Update:
I've added the inserts for the xbox logo. Just print them off and push fit them in place. I needed to sand a thin bit off each edge but then just used the butt of a screwdriver to hammer them in place. I just wish I had some green fila
Sign in to leave a comment
Sign in