S.T.E.V.E X Gantry for 10mm rod and IGUS RJZM

Made for IGUS 10mm aluminium rods, can use steel and or rods etc.
use this clamp: X_Gantry_Bearing_Clamp_0.01 from CRT's original design.

Note: this uses 8mm rods for the Y axis, and 10mm for the X axis!

Igus RJZM-02-08 bearing for the Y rods,
Igus RJUM-02-10 for the carrier. (fits the bearing clamp, it's a tight fit but with a bit of force it should slide in)

Update!
For those that have used this with the End stop mounts I made please download the model again and print it out if you