Thingiverse
Raspberry Pi 3D Printable Logo
by GleaveMakes
35
Downloads
31
Likes
1
Makes
I turned the Raspberry Pi logo into a 3D model!
You can scale the model up or down however you'd like within the slicer software; it will fit on pretty small printers as is; however, if you scale it down too much some of the details may not come through.
If you print the model, then feel free to upload a picture of it under the 'I Made One' section!
You can scale the model up or down however you'd like within the slicer software; it will fit on pretty small printers as is; however, if you scale it down too much some of the details may not come through.
If you print the model, then feel free to upload a picture of it under the 'I Made One' section!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in