Thingiverse
Small 3-Point Angle/Degree Calibration Overhang Test
door PrintsIT
0
Downloads
1
Likes
0
Makes
This is a mix of my single calibration tests
25 Degrees https://www.thingiverse.com/thing:2361995
45 https://www.thingiverse.com/thing:2363713
60 https://www.thingiverse.com/thing:2363721
Having the center calibrated can be deceiving. The bed can slow start to angle up on one end and down on the other as extruder moves across build area.
If you apply glue or spray before printing. These are on the front/left , center and rear/right.
The extruder has to pass over the center test, this
25 Degrees https://www.thingiverse.com/thing:2361995
45 https://www.thingiverse.com/thing:2363713
60 https://www.thingiverse.com/thing:2363721
Having the center calibrated can be deceiving. The bed can slow start to angle up on one end and down on the other as extruder moves across build area.
If you apply glue or spray before printing. These are on the front/left , center and rear/right.
The extruder has to pass over the center test, this
Log in om een reactie achter te laten
Inloggen