Fine tuning FormLabs Form1/1+/2 Fine Tuning

You can get better prints by knowing about the errors in your Form1+. You can even print this at the same time as other models so you don't have to do a special run. And if you post your results, we can discover what is typical is too.

And then measured it with a digital caliper.

And from the various measurements:
X-scale = 0.50% too big
Y-scale = 0.10% too big
X-offset = 1.35mm too far toward hinge
Y-offset = 0.85mm too far toward front
Z-loss = 0.643mm
Platform height = Full adhesi