Thingiverse
Single 40mm Fan Ventilated Side Panel for MPSM
by VA3TNE
10
Downloads
3
Likes
0
Makes
This is too big to print on a stock MPSM. I have the Extended Length print bed from 4DM.
http://mpselectmini.com/mods#dm_extended_beds
It only adds a single 40mm fan, which is enough to reduce the printer interior temp considerably.
I set it to blow air out of the printer. And, I taped a flattened out coffee filter over the ventilation holes in the bottom of the case to prevent dust from being sucked into the case. Coffee filters and tape are cheap enough. I can afford to change i
http://mpselectmini.com/mods#dm_extended_beds
It only adds a single 40mm fan, which is enough to reduce the printer interior temp considerably.
I set it to blow air out of the printer. And, I taped a flattened out coffee filter over the ventilation holes in the bottom of the case to prevent dust from being sucked into the case. Coffee filters and tape are cheap enough. I can afford to change i
Sign in to leave a comment
Sign in