Thingiverse
Half a Pine cone (Photogrammetry)
by viper1990
17
Downloads
15
Likes
0
Makes
Scanned an pinecone I've picked up from a garden in France.
Sliced into half for easy printing on the base. Can be use to stick on walls for Decor if necessary. Creativity is up to you guys!
The model itself is rather small, size it up to 300-400% for a real-life size
This model has 100,000+ Mesh Faces, recommended to slow your printer speed to get the most detail out of it (perhaps 40mm-60mm/s for infills and perimeters)
Go high layer resolution on this one. 0.1mm Layer height wi
Sliced into half for easy printing on the base. Can be use to stick on walls for Decor if necessary. Creativity is up to you guys!
The model itself is rather small, size it up to 300-400% for a real-life size
This model has 100,000+ Mesh Faces, recommended to slow your printer speed to get the most detail out of it (perhaps 40mm-60mm/s for infills and perimeters)
Go high layer resolution on this one. 0.1mm Layer height wi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in