Thingiverse
CTC i3 MK8 radial fan holder (for MK10 extruder)
by jpnurro
122
Downloads
79
Likes
3
Makes
Prusa type radial fan (50mm) holder for MK10 extruder. Doesn't require additional HW (bolts or nuts)
Chassis will be fasten with the extruder fan bolt (remove the 10mm nylon pipe). Additional support is given by the edge of aluminum extruder bracket.
Ps. The nozzle is its own unit so different nozzles can be used. .
The fan is connected to the PWM connector (next to 3 Fan ports). Two wire fan is OK, but you'll need 3-pin connector e.g.https://www.thingiverse.com/thing:2248965
PS. Thoug
Chassis will be fasten with the extruder fan bolt (remove the 10mm nylon pipe). Additional support is given by the edge of aluminum extruder bracket.
Ps. The nozzle is its own unit so different nozzles can be used. .
The fan is connected to the PWM connector (next to 3 Fan ports). Two wire fan is OK, but you'll need 3-pin connector e.g.https://www.thingiverse.com/thing:2248965
PS. Thoug
Sign in to leave a comment
Sign in