Thingiverse
USB Type B extension cord mount for 2020 aluminum
by chr_s
43
Downloads
18
Likes
0
Makes
I wanted an USB input at the front of my Hypercube printer. I found a cheap 50cm USB type B extension cable and made a mount for it.
I use M5x10mm screws with M5 T-nuts to mount to the 2020 frame. I use M3x15mm and M3 Nyloc nuts to mount the cable to the uh...mount.
Note: I mistakenly made the holes M4 size when they're M3, however it still lines up fine and mounts perfectly. I may revisit this and fix it, but again, it works as-is.
Link to the usb cable I used.
I use M5x10mm screws with M5 T-nuts to mount to the 2020 frame. I use M3x15mm and M3 Nyloc nuts to mount the cable to the uh...mount.
Note: I mistakenly made the holes M4 size when they're M3, however it still lines up fine and mounts perfectly. I may revisit this and fix it, but again, it works as-is.
Link to the usb cable I used.
Sign in to leave a comment
Sign in