Thingiverse
TUSH - Filament Spool Holder - No wall contact
by FedeA1968
4
Downloads
2
Likes
0
Makes
This is the remix of TUSH - The Ultimate Spool Holder.
The improvement is the central part that made the correct width.
The central part also cannot permit that the Spool touch the wall in the back
Extra stability.
Print lateral part 2 times, central part 1 time. Add 4 bearing with 8mm hole and 6mm tickness
To assemble just put the bearings onto the pins and press two parts together.
If the fit is too loose you can to glue them together.
The improvement is the central part that made the correct width.
The central part also cannot permit that the Spool touch the wall in the back
Extra stability.
Print lateral part 2 times, central part 1 time. Add 4 bearing with 8mm hole and 6mm tickness
To assemble just put the bearings onto the pins and press two parts together.
If the fit is too loose you can to glue them together.
Sign in to leave a comment
Sign in