Thingiverse
Bus Bar Brackets
by AdamWelch
33
Downloads
28
Likes
0
Makes
This is a set of components to make some bus bar holding brackets. There are also some isolating pieces of different lengths depending on your needs.
The main bracket ends include an identifier for the positive and negative bar. Change your filament at around 98% complete to a contrasting colour or simply use a sharpie after the print is complete! The brackets are designed to take bus bar measuring 20mm*5mm.
The nut holders are for M5 nuts and allow a bit of play in case your drilled bu
The main bracket ends include an identifier for the positive and negative bar. Change your filament at around 98% complete to a contrasting colour or simply use a sharpie after the print is complete! The brackets are designed to take bus bar measuring 20mm*5mm.
The nut holders are for M5 nuts and allow a bit of play in case your drilled bu
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in