Wanhao i3 Control Box Rear Panel for Modular Connections

I wanted to be able to disconnect the control box of my Wanhao Duplicator i3 v2.1 from the printer, largely because this makes it much easier to mount the printer inside an enclosure (to let ABS print in a warm environment) while the control box is outside for ease of access and good cooling for the motor drivers and hotbed mosfet.

This print makes it easier to do that.

It's still a lot of work, though. You'll need:
- 2 complete xt60 connectors (male and female sides)
- 1 female d-sub