Thingiverse
Fidget Spinner Bearing Alternative
by pmhesse
5
Downloads
6
Likes
0
Makes
Say you're printing a fidget spinner model, but you don't have a 608 bearing handy. This is a two-piece alternative to the bearing which you can print and use instead. Is it as good as a bearing? Heck no! Will it spin so you can test it out? Absolutely!
Designed in two pieces to snap together on either side of a 22mm hole where a 608 bearing would normally fit.
Designed in two pieces to snap together on either side of a 22mm hole where a 608 bearing would normally fit.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in