Thingiverse
ATX PSU (Power Supply Unit) Holder for Anet A8 and Others
by TecNerd
41
Downloads
16
Likes
0
Makes
This is a simple ATX PSU holder for the Anet A8 printer, mounted on the right side. May fit other printer models but can't confirm. With this design the PSU can be easily placed and re-used in the future. No screws needed, no glue, just gravity.
It can be mounted lower than seen in the photos, place it where you want on the right side, drill six holes and mount the PSU holder with six M3x18mm screws and nuts. You should have a few left after the first assembly of the printer.
Attention: T
It can be mounted lower than seen in the photos, place it where you want on the right side, drill six holes and mount the PSU holder with six M3x18mm screws and nuts. You should have a few left after the first assembly of the printer.
Attention: T
Sign in to leave a comment
Sign in