Thingiverse
RJ4JP-01-08 Split Carrier
99
Downloads
40
Likes
0
Makes
This is a remix of the RJMP-01-08 split bearing carrier by crashc0de. My intention is to make it fit the RJ4JP-01-08 bearings which are 1mm smaller in diameter.
26/06/17 - Uploaded another version which is 0.5mm shallower as there was a small gap at the edge of the bearing. I will leave the old version here too as it may depend on print tolerance. I would say to try this one first and if it doesn't fit all the way in with both halves assembled, try the other one.
25/06/17 - Uploaded a new
26/06/17 - Uploaded another version which is 0.5mm shallower as there was a small gap at the edge of the bearing. I will leave the old version here too as it may depend on print tolerance. I would say to try this one first and if it doesn't fit all the way in with both halves assembled, try the other one.
25/06/17 - Uploaded a new
Sign in to leave a comment
Sign in