Thingiverse
Wanhoa i3 Mosfet bracket
by rcflyers
28
Downloads
10
Likes
2
Makes
Bracket for the MOSFET upgrade on a Wanhao i3 V2.
The 4 upstands for the MOSFET have a 2.5mm hole in them so you can screw an M3 screw straight in to them
No drilling required, just remove the 4 circuit board screws and slip this bracket over the 2 case studs nearest to the LCD display.
Then refit the board and connect the wiring.
The 4 upstands for the MOSFET have a 2.5mm hole in them so you can screw an M3 screw straight in to them
No drilling required, just remove the 4 circuit board screws and slip this bracket over the 2 case studs nearest to the LCD display.
Then refit the board and connect the wiring.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in