Thingiverse
XT60 connector support for Anet A8 heatbed
by Pharaoh
19
Downloads
9
Likes
0
Makes
After some long run print, my Anet A8 headbed connector started to melt.
So I wanted to change it to XT60 connectors which are more reliable.
I didn't want to solder directly the wires to the headbed due to the possible wire stress break and with a connector it's easier to perform maintenance on the printer.
It was printed in PLA. After 4 months of use and many long prints with PLA, ABS and PETG, I noticed a small bending (less than 1mm) at the middle of the support. So maybe for more str
So I wanted to change it to XT60 connectors which are more reliable.
I didn't want to solder directly the wires to the headbed due to the possible wire stress break and with a connector it's easier to perform maintenance on the printer.
It was printed in PLA. After 4 months of use and many long prints with PLA, ABS and PETG, I noticed a small bending (less than 1mm) at the middle of the support. So maybe for more str
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in