Thingiverse
Geeetech i3 Pro B Cooling Fan Duct, 40mm holes (50mm fan)
by prof7bit
39
Downloads
25
Likes
1
Makes
Note that the holes are 40mm apart, the fan would have 50mm edge length, I have been told these are sold as 50mm fans. Please make sure these measurements are correct before buying a fan.
rotate 135 degrees until it lies flat, the pipe looking straight upwards.
When slicing (at least with slic3r) you might need to carefully look over the layers of the conical section to make sure it will print everything with the same number of lines and will not put some needless additional gap filling is
rotate 135 degrees until it lies flat, the pipe looking straight upwards.
When slicing (at least with slic3r) you might need to carefully look over the layers of the conical section to make sure it will print everything with the same number of lines and will not put some needless additional gap filling is
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in