Thingiverse
Bed Levelling Disk
by Sidhiscocks
35
Downloads
15
Likes
0
Makes
This is a simple part to set up the correct nozzle to bed thickness taking only a few minutes to print it is a quick and accurate method to level the bed to the correct nozzle gap.
Print these disks near to each of the adjustment screws at 0.2mm layer height (Disk is 0.2mm thick) measure the disk and then adjust the screw to correct, reprint, measure and adjust again to verify, Repeat as necessary.
Although it is show below for the Wanhao it is also suitable for other printers, I have a WDi3
Print these disks near to each of the adjustment screws at 0.2mm layer height (Disk is 0.2mm thick) measure the disk and then adjust the screw to correct, reprint, measure and adjust again to verify, Repeat as necessary.
Although it is show below for the Wanhao it is also suitable for other printers, I have a WDi3
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in